USB Flash Drive Cryptex v 2 free 3d print model download

Make your USB stick physically safe by printing a combination lock for it. The NSA won?t stand a chance!Print SettingsPrinter Brand:RepRapPrinter:Prusa Mendel i3Rafts:Doesn?t MatterSupports:Doesn?t MatterNotes:Print: Case_Top, Case_Bottom, Cover, Jacket and 4 rings of your choosing. I printed the design both on a Reprap i3 and a professional SLS printer. Both turned out great. Post-PrintingFlash drive casePrint both case shells, clean them up and glue them together with the flash drive circuit inside. The design is fitted for an INTENSO RAINBOW LINE drive I had laying around. If you are using a different drive, you may have to do some carving.Spacing for the circuit board is 40 x 15.8 x 4 mm. Make sure the shells fit nicely. I used a paper binder clip to squeeze the halves together. After the glue is dry, smooth the edges and remove residues of the glue.CryptexSlide the four Rings you chose onto the jacket. Make sure the orientation of the rings is right (compare to the picture). Add fill some glue into the notch inside of the cover and snap the jacket onto is. If it dies not fit, twist the parts around untiil they snap together. the is a little fitting key inside the notch to maintain the right orientation of the parts.Credits:Freakazoid Rate this 3D modelDownload 3D modelsFileFile size USB_Flash_Drive_Cryptex_v26 MB

USB Flash Drive Cryptex v 2 free 3d print model download