Speedlight Flash Diffuser for Macro (Yongnuo & Canon) free 3d print model download

This Speedlight flash diffuser for macro photography has been designed using the Yongnuo range of flashes and attaches to the diffuser cap which comes standard with your Canon or Yongnuo Speedlight.The macro diffuser slips over the diffuser cap and acts to better direct and further diffuse light for use with macro photography. It has been designed to direct the light down and towards the front of nearby objects.The macro diffuser increases the diffused area of the standard diffuser cap from ~35cm^2 to ~200cm^2, an increase of 570%.The macro diffuser is designed with a flange which can secure any diffusing material of choice using bulldog or slide clips.It is recommended to line the inside of the macro diffuser with a reflective material to better spread the light and utilise the full volume of the housing. Some 1:1 templates of the internal walls have been included which can be used to cut this reflective material to the correct size.It has been designed for use with lenses of lengths varying from the Canon 60mm Macro to the Canon 100mm Macro. Longer lengths may result in a shadow being cast, however the speedlight flange can be lengthend to compensate if required.Requires a print bed size of minimum 240mm x 150mm x 150mmPrint SettingsPrinter Brand:FlashForgePrinter:DreamerRafts:NoSupports:NoResolution:0.15 ? 0.25mmInfill:15%Notes:Print with the large flange facing down on the bed to allow for printing without any support material.Credits:Ospi Rate this 3D modelDownload 3D modelsFileFile size Speedlight_Flash_Diffuser_for_Macro_Yongnuo___Canon12 MB

Speedlight Flash Diffuser for Macro (Yongnuo & Canon) free 3d print model download