Pi Eye ? Raspberry Camera 2.1 mountable case free 3d print model download

A complete new design case for the Raspberry Pi Camera 2.1.This has a snap together case with ball mount to allow it to be adjust in different angles. The design has a flat mount and a corner mount.When inserting the ball into the mount, it will be tight. If the mount breaks then try scaling the mount slightly bigger.I printed mine in fine mode to give the ball a smoother surface to allow better adjusting of the camera. Attach cable to camera Place camera in front cover on alignment pins Install back cover straight down. Use a pair of pliers to open the opposing keeper.Print SettingsPrinter Brand:PowerSpecPrinter:PowerSpec 3D ProRafts:NoSupports:YesResolution:Fine 0.1Infill:80%Notes:Depending on printer model and setting you may need to scale the mounts to get the best fit if it seems loose. You can also use a small piece of tape on the ball to fill the gap.Credits:TraylorHead Rate this 3D modelDownload 3D modelsFileFile size Pi_Eye_-_Raspberry_Camera_2.1_mountable_case466 KB

Pi Eye ? Raspberry Camera 2.1 mountable case free 3d print model download