Mini Lighthouse re-mix lighted with neopixels free 3d print model download

Redesigned base to fit Adafruit neopixel 16 bit ring https://www.adafruit.com/product/1463 and trinket mini controller https://www.adafruit.com/product/1501Scaled up mid section and top to fit the new base.Plug it into your usb port.Use the ?Strand Test? Arduino code from Adafruit to drive the neopixels08/05/2017 Created a ?Standalone base? so you don?t have to plug it into a USB port. Pick the base that you prefer. Uses a pushbutton toggel switch https://www.amazon.com/dp/B01KJHR3W6?psc=1 to turn it on and off. All components are glued in with hot glue.08/07/2017 Added an LED holder. Glue this into the bottom of the top item of the lighthouse. You can glue a 5 mm LED into it and run a wire down the center of the tower. Attach it to a PWM pin on the Trinket ( I used pin #0) and use the code I provide to blink ( and fade) the LED.Credits:bonnette Rate this 3D modelDownload 3D modelsFileFile size Mini_Lighthouse_re-mix_lighted_with_neopixels1 MB

Mini Lighthouse re-mix lighted with neopixels free 3d print model download