GoPro Plastic Bottle Cap Mount free 3d print model download

GoPro Plastic Bottle Cap Mount The idea is to use any plastic bottle as a grip/stand/floaty at the same time. I saw plenty of solutions here on Thingiverse as well, but I did not find any of them perfect. The concept is brilliant, you get basically a free GoPro grip, which at the same time makes your camera float. Though a 3D print is most likely not 100% watertight, it is good enough to make your GoPro float in water.I designed it 3D-print friendly, but also with common engineering sense: no need for supports, the big inner overhang is sloped sharp edges are rounded: especially important in high stress areas also the edges sitting on the printbed are smoothened: they could cut your hand otherwise when tightening the cap walls are thick enough that some infill will be printed to get a sturdy part (two other prints I tried from the site where bendy, weak) yet tried to keep size to the minimum not to get a bulky part surface is grooved to create better gripI used the standard thread called PCO1881. This is the newer style ? lightweight and lower profile, against the older PCO1810. Outside diameter is 27.4 mm and pitch is 2.7 mm.The drawing was printed, used and tested diving in a lake with the GoPro Session and I was satisfied with it. I hope you will enjoy it!Print SettingsPrinter Brand:PrusaPrinter:Prusa CloneRafts:NoSupports:NoResolution:0.2 mm layer hightInfill:minimum 20% suggestedNotes:I used PETG with 50mm/s print speed, 2 mm retraction. How I Designed ThisThe part was designed in Autodesk Fusion 360 by measuring the physical parts with a caliper gauge.Credits:behin Rate this 3D modelDownload 3D modelsFileFile size GoPro_Plastic_Bottle_Cap_Mount1 MB

GoPro Plastic Bottle Cap Mount free 3d print model download